RAM 1500 Truck 4WD V8-4.7L (2008)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor - Removal
4.7L V-8
The Crankshaft Position (CKP) sensor is located at the right-rear side of the engine cylinder block. It is positioned and bolted into a machined hole in the
engine block.
1. Raise vehicle.
2. Disconnect CKP electrical connector at sensor.
3. Remove CKP mounting bolt (2).
4. Carefully twist sensor (1) from cylinder block.
5. Remove sensor from vehicle.
6. Check condition of sensor O-ring.
