RAM 1500 Truck 4WD V8-4.7L (2008)
2. Inspect the steering damper bracket mounting nuts by putting a 13 mm box-end wrench onto the nut (Figure 1):
>
If a 13 mm wrench fits the steering damper bracket mounting nuts, the bracket and fasteners must be replaced. Continue with Step 3 of this
procedure.
>
If a 13 mm wrench does not fit the steering damper bracket mounting nuts, the bracket does not require replacement. Continue with Step 4 of this
procedure.
3. Replace the steering damper bracket and fasteners using the following procedure:
a. Remove and save the steering damper-to-damper bracket mounting
nut (Figure 2).