RAM 1500 Truck 4WD V8-4.7L (2008)
1. Raise vehicle.
2. Place a suitable fluid catch pan under the transmission.
3. Remove the wiring connector from the output speed sensor (2).
NOTE: The speed sensor bolt has a sealing patch applied from the factory. Be sure to reuse the same bolt.
4. Remove the bolt holding the output speed sensor to the transmission case.
5. Remove the output speed sensor (2) from the transmission case.
Installation
INSTALLATION
1. Install the output speed sensor (2) into the transmission case.
NOTE: Before installing the speed sensor bolt, it will be necessary to replenish the sealing patch on the bolt using MOPAR(R) Lock &
Seal Adhesive.
2. Install the bolt to hold the output speed sensor into the transmission case. Tighten the bolt to 9 Nm (80 in.lbs.).
3. Install the wiring connector onto the output speed sensor
4. Verify the transmission fluid level. Add fluid as necessary.
5. Lower vehicle.
