RAM 1500 Truck 4WD V8-4.7L (2008)
4. Disconnect wires at solenoid case connector (1).
5. Remove the transmission range sensor (2) See: Sensors and Switches - A/T/Transmission Position Switch/Sensor/Service and Repair/48RE
Automatic Transmission/Removal .
6. Position drain pan under transmission oil pan.
7. Remove transmission oil pan and gasket.
8. Remove fluid filter from valve body.
9. Remove bolts attaching valve body to transmission case.
10. Lower valve body enough to remove accumulator piston and springs.
11. Work manual lever shaft and electrical connector out of transmission case.
12. Lower valve body (1), rotate valve body away from case, pull park rod (3) out of sprag, and remove valve body.
Installation
INSTALLATION
1. Check condition of O-ring seals (1) on valve body harness connector (2). Replace seals on connector body if cut or worn.
