RAM 1500 Truck 4WD V8-4.7L (2008)
15. Install retainer (8), limit valve and spring (7), and 2-3 throttle plug (4) into the limit valve housing (5).
16. Install the throttle pressure spring and plug (12) and plug sleeve (11).
17. Install pressure plug cover (10) and cover plate (6). Tighten screws to 4 Nm (35 in. lbs.).
18. Install limit valve housing (5) and cover plate (6). Tighten screws to 4 Nm (35 in. lbs.).
BOOST VALVE TUBE AND BRACE
1. Position valve body assembly so lower housing (2) is facing upward.
2. Lubricate tube ends and housing ports with transmission fluid or petroleum jelly.
3. Start tube in lower housing port first. Then swing tube downward and work opposite end of tube into upper housing port.
4. Insert and seat each end of tube in housings.
5. Slide tube brace (2) under tube and into alignment with valve body screw holes.
6. Install and finger tighten three screws that secure tube brace to valve body housings.
7. Bend tube brace tabs up and against tube to hold it in position.
8. Tighten all valve body housing screws to 4 Nm (35 in. lbs.) torque after tube and brace are installed. Tighten screws in diagonal pattern starting at
center and working outward.
3-4 ACCUMULATOR
