RAM 1500 Truck 4WD V8-4.7L (2008)
1. Position converter clutch valve (4) and 3-4 shift valve (3) springs in housing.
2. Loosely attach accumulator housing (2) with right-side screw (1). Install only one screw at this time as accumulator must be free to pivot upward
for ease of installation.
3. Install 3-4 shift valve and spring (3).
4. Position plug (2) on end of converter clutch valve spring. Then compress and hold springs and plug in place with fingers of one hand.
5. Swing accumulator housing upward over valve springs and plug.
6. Hold accumulator housing firmly in place and install remaining two attaching screws. Be sure springs and clutch valve plug are properly seated.
Tighten screws to 4 Nm (35 in. lbs.).
VALVE BODY FINAL
1. Insert manual lever detent spring in upper housing.
2. Position detent ball on end of spring. Then hold detent ball and spring in detent housing with Retainer Tool 6583 (1).
