RAM 1500 Truck 4WD V8-4.7L (2008)
9. Press down one side of the bearing cage (3) to gain access to the ball at the opposite side.
NOTE: If joint is tight, use a hammer and brass drift to loosen the bearing hub. Do not contact the bearing cage with the drift.
10. Remove ball (4) from the bearing cage (3).
11. Repeat step above until all six balls are removed from the bearing cage.
12. Lift cage and inner race (2) upward and out from the housing (1).
13. Turn inner race 90° in the cage and rotate the inner race/hub out of the cage.
Installation
INSTALLATION
