RAM 1500 Truck 4WD V8-4.7L (2008)
3. Reconnect the left headlamp and dash wire harness (1) connector to the washer pump/motor unit connector receptacle (3).
4. Reconnect the left headlamp and dash wire harness connector to the washer fluid level switch connector receptacle (5).
5. Reconnect the reservoir washer hose (4) to the barbed nipple of the inline fitting at the engine compartment washer hose in the right headlamp and
dash wire harness.
6. Engage the reservoir washer hose into the integral routing clips on the top of the radiator fan shroud.
7. Refill the washer reservoir (2) with the washer fluid drained from the reservoir during the removal procedure.
8. Reconnect the battery negative cable.
6.7L Diesel Engine
6.7L DIESEL ENGINE
1. Position the locator post (3) on the bottom of the coolant reserve bottle into the locator hole in the bracket (4) at the base of the left vertical
member of the radiator support on the left side of the engine compartment.
2. Install and tighten the two screws (2) that secure the washer reservoir (1) to the left vertical member and left lower horizontal member of the
radiator support. Tighten the screws to 10 Nm (85 in. lbs.).
