RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
Antenna Mast: Technical Service Bulletins
Audio System - Revised Antenna Mast Installation
NUMBER: 08-058-05
GROUP: Electrical
DATE: October 29, 2005
SUBJECT:
Revised Radio Antenna Mast Installation Procedure
MODELS:
2005 - 2006
(DR/DH/D1)
Ram Truck
2005 - 2006
(HB)
Durango
2005 - 2006
(ND)
Dakota
2005 - 2006
(PL)
Neon
2005 - 2006
(PT)
PT Cruiser
2005 - 2006
(RS)
Town & Country/Caravan
DISCUSSION:
The installation procedure for the radio antenna mast has been revised. Please use the following procedure when installing the antenna mast to the
antenna base.
CAUTION:
Do not exceed the torque specification in the step below. Damage to the antenna mast and/or base may occur if the tightening torque is exceeded.
1.
Install antenna mast to antenna base. Finger tighten the antenna mast until it is fully seated on antenna base; no gap between the mast and base.
Using a torque wrench, tighten the antenna mast to 3.4 - 3.6 N.m (30 - 32 in.lbs.) (Fig. 1).
POLICY:
Information Only
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
