RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
Measure the resistance between the (C34) Common Door Driver circuit and the applicable door driver circuit in the A/C Heater Control C1
harness connector.
Q: Is the resistance below 30.0 ohms?
YES: Replace the door actuator. Perform BODY VERIFICATION TEST - VER 1. See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Body Verification Test
NO: Go To 5
4. CHECK THE DOOR DRIVER CIRCUIT IDENTIFIED IN THE ACTUATOR CIRCUIT TEST MESSAGE FOR A SHORT TO
VOLTAGE
Turn the ignition off.
Disconnect the A/C Heater Control C1 harness connector.
Turn the ignition on.
Measure the voltage of the applicable door driver circuit.
Q: Is there any voltage present?
YES: Repair the door driver circuit for a short to voltage. Perform BODY VERIFICATION TEST - VER 1. See: Powertrain
Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification
Tests/Body Verification Test
NO: Go To 5
