RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
-
Diagnose and repair any DTCs before proceeding with this test.
-
Ensure that the PCM passes the Shift Lever Test with the DRBIII(R) before proceeding with this test.
Turn the ignition on.
With the DRBIII(R), read DTCs.
Q: Does the DRBIII(R) display any MIC or PCM DTCs?
YES: Refer to the correct symptom list for problems related to DTCs. Perform BODY VERIFICATION TEST - VER 1. See: Powertrain
Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification
Tests/Body Verification Test
NO: Go To 2
2. INSTRUMENT CLUSTER
Perform the Instrument Cluster Self Test.
Turn the ignition off.
Press and hold the Trip/Reset button.
Turn the ignition on.
Observe the PRNDL display during the Self Test.
Q: Did any part of the VF display fail to illuminate?
YES: Replace and program the Instrument Cluster. Perform BODY VERIFICATION TEST - VER 1. See: Powertrain Management/Computers
and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Body Verification Test
NO: The condition is not present at this time. Monitor DRBIII(R) parameters while wiggling the related wiring harness, refer to any Technical
Service Bulletins (TSB) that may apply. Visually inspect the related wiring harness and connector terminals. Perform BODY VERIFICATION
TEST - VER 1. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and
Associated Procedures/Verification Tests/Body Verification Test
Seat Belt Warning Indicator Always Off
SEAT BELT WARNING INDICATOR ALWAYS OFF
