RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
9. Install the boot seals into the caliper seal bores and center the seals in the bores.
10. Install mounting bolt bushings into the boot seals and insure seal lip is engaged into the bushing grooves at either end of the bushing.
11. Install caliper bleed screw.
INSTALLATION
REAR
1. Install caliper (6) to the caliper adapter (1).
2. Coat the caliper mounting slide pin bolts (3) with silicone grease. Then install and tighten the bolts to 30 Nm (22 ft. lbs.).
3. Install the brake hose banjo bolt if removed.
4. Install the brake hose (4) to the caliper (6) with new seal washers and tighten fitting bolt to 27 Nm (245 inch lbs.).
CAUTION: Verify brake hose is not twisted or kinked before tightening fitting bolt.
5. Bleed the base brake system.
6. Install the wheel and tire assemblies.
7. Remove the supports and lower the vehicle.
8. Verify a firm pedal before moving the vehicle.
