RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
1. Lubricate caliper pistons, piston seals and piston bores with clean, fresh brake fluid.
NOTE: Verify seal is fully seated and not twisted.
2. Install new piston seals (3) into caliper bores (2).
3. Lightly lubricate lip of new boot with silicone grease. Install boot on piston and work boot lip into the groove at the top of piston (3).
4. Stretch boot (2) rearward to straighten boot folds, then move boot forward until folds snap into place.
5. Install piston (3) into caliper bore and press piston down to the bottom of the caliper bore by hand or with hammer handle.
6. Seat dust boot in caliper (2) with Handle C-4171 (1) and Installer (3):
^
54 mm caliper: Installer C-3716-A
7. Install the second piston and dust boot.
8. Lubricate caliper mounting bolt bushings, boot seals and bores with Mopar(R) brake grease or Dow Corning 807 grease only.
CAUTION: Use of alternative grease may cause damage to the boots seals.
