RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
2. Install the caliper adapter mounting bolts (2) and tighten to 176 Nm (130 ft. lbs.) LD or tighten to 339 Nm (250 ft. lbs.) HD.
3. Install the disc brake caliper (1).
4. Install the tire and wheel assembly.
5. Remove the support and lower the vehicle.
Rear
ADAPTER - DISC BRAKE CALIPER
REMOVAL
REAR
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. Drain a small amount of fluid from master cylinder brake reservoir with a clean suction gun.
4. Bottom the caliper pistons into the caliper by prying the caliper over.
5. Remove the caliper slide bolts.
6. Remove the disc brake caliper from the mount.
CAUTION: Never allow the disc brake caliper to hang from the brake hose. Damage to the brake hose will result. Provide a suitable support to hang
the caliper securely.
7. Remove the inboard and outboard brake pads (1).
8. Remove the anti-rattle clips (2).
9. Remove the caliper adapter mounting bolts (4).
