RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
CAUTION: Ensure that retainers (2) and rocker arms (4) are not overlapped when torquing bolts.
CAUTION: Verify that pushrod is installed into rocker arm (4) and tappet correctly while installing rocker shaft assembly. Recheck after rocker shaft
has been torqued to specification.
CAUTION: The rocker shaft assemblies are not interchangeable between intake and exhaust. The intake rocker arms are marked with the letter "I".
3. Install rocker shaft assemblies in the same order as removed.
4. Tighten the rocker shaft bolts to 22 Nm (195 inch lbs.) torque, using the sequence provided.
CAUTION: DO NOT rotate or crank the engine during or immediately after rocker arm installation. Allow the hydraulic roller tappets adequate time
to bleed down (about 5 minutes).
