RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
Oil Filter: Service and Repair
FILTER - ENGINE OIL
REMOVAL
All engines are equipped with a high quality full-flow, disposable type oil filter. Daimler/Chrysler Corporation recommends a Mopar(R) or equivalent
oil filter be used.
1. Position a drain pan under the oil filter.
2. Using a suitable oil filter wrench loosen filter (3).
3. Rotate the oil filter counterclockwise to remove it from the cylinder block oil filter boss.
4. When filter separates from cylinder block oil filter boss, tip gasket end upward to minimize oil spill. Remove filter from vehicle.
NOTE: Make sure filter gasket was removed with filter.
5. With a wiping cloth, clean the gasket sealing surface of oil and grime.
INSTALLATION
1. Lightly lubricate oil filter gasket (2) with engine oil.
2. Thread filter (3) onto adapter nipple. When gasket makes contact with sealing surface, hand tighten filter one half turn, or 180°, do not over
tighten.
3. Add oil, verify crankcase oil level and start engine. Inspect for oil leaks.
