RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
housing.
NOTE: If the foam seal on the air inlet housing is deformed or damaged, it must be replaced.
5. If required, disassemble the air inlet housing.
INSTALLATION
NOTE: If the foam seal on the air inlet housing is deformed or damaged, it must be replaced.
1. Position the air inlet housing (2) onto the top of the HVAC housing (3).
2. Engage the two retaining clips (1) that secure the front of the air inlet housing to the HVAC housing.
3. Install the two screws (3) that secure the rear of the air inlet housing (2) to the top of the HVAC housing (5). Tighten the screws to 2.2 N.m (20
in.lbs.).
4. Install the recirculation door actuator (1) onto the air inlet housing.
5. Connect the HVAC wire harness (4) to the recirculation door actuator.
6. Install the HVAC housing assembly.
HVAC Housing - Removal and Installation
REMOVAL
WARNING:
