RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
Compass: Service and Repair
Module - Compass Temperature
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the overhead console (1) from the head-liner.
3. Remove the screws (4) that secure the Electronic Overhead Module (EOM) (2) to the overhead console housing (1).
4. Disconnect the overhead console wire harness connector from the EOM connector receptacle.
5. Remove the EOM (2) from the overhead console housing (1).
INSTALLATION
NOTE: If a new Electronic overhead Module (EOM) has been installed, the compass will have to be calibrated and the variance set.
1. Position the Electronic overhead Module (EOM) (2) onto the overhead console housing (1).
2. Reconnect the overhead console wire harness connector to the EOM connector receptacle.
3. Install the screws (4) that secure the EOM (2) to the overhead console housing (1). Tighten the screws to 2.2 N.m (20 in.lbs.).
4. Install the overhead console (1) onto the headliner.
