RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
Fog/Driving Lamp Bulb: Service and Repair
REMOVAL
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will
result.
1. Disconnect and isolate the battery negative cable.
2. Reach under and behind the front fascia to access the front fog lamp housing (1) on the back of the front bumper (4).
3. Disconnect the wire harness connector (3) from the fog lamp bulb (2).
4. Firmly grasp the bulb on the back of the housing and rotate it counterclockwise about 30 degrees to unlock it.
5. Pull the bulb straight out from the keyed opening in the housing.
INSTALLATION
CAUTION:
-
Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket
and/or the lamp wiring.
-
Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.
1. Align the fog lamp bulb (2) with the keyed opening on the back of the front fog lamp housing (1).
2. insert the bulb into the housing until it is firmly seated.
3. Rotate the bulb clockwise about 30 degrees to lock it into place. The bulb connector receptacle should be pointed straight downward.
4. Reconnect the wire harness connector (3) to the bulb.
5. Reconnect the battery negative cable.
