dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Diagnostic Trouble Code Descriptions|Page 2532 > < Diagnostic Trouble Code Descriptions|Page 2530
Page 54
background image

-

Horn relay output circuit open

-

Horn switch

-

Horn switch ground

-

Clockspring

-

Horn switch sense open

-

Integrated power module

-

Instrument cluster

-

Front control module

Diagnostic Test

1. HORN RELAY CONTROL CIRCUIT DTC ACTIVE

Turn the ignition on.
With the DRBIII(R), read FCM DTC's.

Q:  Does the DRBIII(R) display a HORN RELAY CONTROL CIRCUIT DTC active?

YES:  Refer to symptom list. Perform BODY VERIFICATION TEST - VER 1.  See: Testing and Inspection/Diagnostic Trouble Code Tests and
Associated Procedures/Verification Tests/Body Verification Test
NO:  Go To 2

2. ACTUATE HORN RELAY

With the DRBIII(R), actuate the Horn Relay.

Q:  Do the horns operate?

YES:  Go To 3
NO:  Go To 7

3. HORN SWITCH

WARNING:  TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BEFORE PROCEEDING.

CAUTION:  Do not place an intact undeployed airbag face down on a hard surface, the airbag will propel into the air if accidentally deployed,
and could result in serious or fatal injury.

Gain access to the horn switch.
Measure the resistance of the Horn Switch ground circuit.

Q:  Is the resistance below 5.0 ohms?

YES:  Go To 4
NO:  Repair the horn switch ground as necessary. Perform BODY VERIFICATION TEST - VER 1.  See: Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests/Body Verification Test

4. HORN SWITCH

WARNING:  TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BEFORE PROCEEDING.

CAUTION:  Do not place an intact undeployed airbag face down on a hard surface, the airbag will propel into the air if accidentally deployed,
and could result in serious or fatal injury.

Gain access to the horn switch connector.

WARNING:  TURN THE IGNITION ON, THEN RECONNECT THE BATTERY.

Momentarily connect a jumper wire between the Horn Switch Sense circuit at the Horn switch connector and ground.

Q:  Did the horns sound?

YES:  Replace the horn switch. Perform BODY VERIFICATION TEST - VER 1.  See: Testing and Inspection/Diagnostic Trouble Code Tests
and Associated Procedures/Verification Tests/Body Verification Test
NO:  Go To 5

5. CLOCKSPRING

Diagnostic Trouble Code Descriptions|Page 2532 > < Diagnostic Trouble Code Descriptions|Page 2530