RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
-
Electronic overhead module
1. ELECTRONIC OVERHEAD MODULE
NOTE:
-
Diagnose and repair any FCM, PCM, or Communication DTCs before proceeding with this test.
-
Ensure that the EOM has been configured for the correct fuel tank size. Use the DRBIII(R) to verify or modify the fuel tank size
configuration.
Perform the EOM Self Test. See: Accessories and Optional Equipment/Driver/Vehicle Information Display/Testing and
Inspection/Self-Diagnostic Test
The self test can be performed with the DRBIII(R) or manually using the following procedure:
Turn the ignition off.
Press and hold the RESET and C/T buttons.
Turn the ignition on.
Continue to hold both buttons until the software version is displayed, then release the buttons.
Observe the EOM display when the self test is complete.
Q: Did the EOM display "FAILED SELF TEST"?
YES: Replace and configure the Electronic Overhead Module. Perform BODY VERIFICATION TEST - VER 1. See: Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Body Verification Test
NO: Test Complete.
CMTC or EVIC Inoperative
CMTC OR EVIC INOPERATIVE