RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
Perform the EOM Self Test. See: Accessories and Optional Equipment/Driver/Vehicle Information Display/Testing and
Inspection/Self-Diagnostic Test
Turn the ignition off.
Press and hold the C/T and Reset buttons.
Turn the ignition on.
NOTE: NOTE: The self test can also be performed using the DRBIII(R).
Observe the EOM display at the conclusion of the self test.
Q: Does the EOM display "Passed Self Test"?
YES: Test Complete.
NO: Replace and configure the EOM. Perform BODY VERIFICATION TEST - VER 1. See: Testing and Inspection/Diagnostic Trouble Code
Tests and Associated Procedures/Verification Tests/Body Verification Test
Trip Odometer Inaccurate or Wrong
TRIP ODOMETER INACCURATE OR WRONG
POSSIBLE CAUSES
-
Electronic overhead module
1. ELECTRONIC VEHICLE INFORMATION CENTER
NOTE:
-
Diagnose and repair any FIDEM, PCM, or Communication DTCs before proceeding with this test.
-
Ensure that the OEM has been configured for the correct fuel tank size. Use the DRBIII(R) to verify or modify the fuel tank size
configuration.
Perform the EOM Self Test. See: Accessories and Optional Equipment/Driver/Vehicle Information Display/Testing and
Inspection/Self-Diagnostic Test
The self test can be performed with the DRBIII(R) or manually using the following procedure:
Turn the ignition off.
Press and hold the RESET and C/T buttons.
Turn the ignition on.
Continue to hold both buttons until the software version is displayed, then release the buttons.
Observe the EOM display when the self test is complete.
Q: Did the EOM display "FAILED SELF TEST"?
YES: Replace and configure the Electronic Overhead Module. Perform BODY VERIFICATION TEST - VER 1. See: Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Body Verification Test
NO: Test Complete.
All Door Locks Inoperative
ALL DOOR LOCKS INOPERATIVE