RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
Turn the ignition off.
Disconnect the Seat Belt Switch harness connector.
Connect a jumper wire between cavity 1 and cavity 2.
Turn the ignition on.
Observe the Seat Belt Warning Indicator.
Q: Did the Seat Belt Warning Indicator illuminate?
YES: Replace the Seat Belt Switch. Perform BODY VERIFICATION TEST - VER 1. See: Testing and Inspection/Diagnostic Trouble Code
Tests and Associated Procedures/Verification Tests/Body Verification Test
NO: Go To 4
4. CHECK THE (Z951) SEAT BELT SWITCH GROUND CIRCUIT FOR AN OPEN
Turn the ignition off.
Measure the resistance between ground and the (Z951) Seat Belt Switch circuit.
Q: Is the resistance below 5.0 ohms?
YES: Go To 5
NO: Repair the (Z951) Seat Belt Switch Ground circuit for an open. Perform BODY VERIFICATION TEST - VER 1. See: Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Body Verification Test
5. CHECK THE (G10) SEAT BELT SWITCH SENSE CIRCUIT FOR AN OPEN
