RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
3.
Log into DealerCONNECT. Proceed to: Service/Repair - Flash.
4.
Select vehicle Year, Model, and Engine (YME). Then select the "Submit" button at the bottom of the screen.
5.
Compare the calibration part number available for flash reprogramming to the module part number recorded earlier. Select the new calibration if
applicable.
6.
Download the new calibration to the PC.
7.
Using the "DRBIII - WINFLASH II" application on the PC, download the flash calibration file to the DRBIII(R) from the PC.
8.
Disconnect the DRBIII(R) from the PC and NULL modem cable.
9.
Open the hood, install a battery charger and verify that charging rate provides approximately 13.5 volts.
10.
Connect the DRBIII(R) to the vehicle.
11.
Turn the ignition switch to the "Run" position (engine not running).
12.
Reprogram the ECM by downloading the flash from the DRBIII(R) to the vehicle. Using the DRBIII(R) select:
a.
"Vehicle Flash"
b.
Follow the directions on the DRBIII(R) screen. When the flash process is complete, proceed to the next step.
13.
Reset the "Pinion Factor" as necessary.
14.
Perform the transmission Quick Learn Procedure as necessary.
15.
Update the Sentry Key Immobilizer Module (SKIM) or Sentry Key Remote Entry Module (SKREEM), Secret Key data as necessary.
NOTE:
Due to the ECM programming procedure, a DTC may be set in other modules (TCM, BCM, MIC, SKIM, etc.) within the vehicle, if so
equipped. Some DTC's may cause the MIL to illuminate. Check all modules using "Module Scan", record the DTC's, and erase these DTC's
prior to returning the vehicle to the customer. Erase any DTC's in the ECM only after all other modules have had their DTC's erased.
NOTE:
The following step is required by law when reprogramming a PCM and/or TCM.
