RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
Main Relay (Computer/Fuel System): Description and Operation
PCM Output
The 5-pin, 12-volt, Automatic Shutdown (ASD) relay is located in the Power Distribution Center (PDC). Refer to label on PDC cover for relay location.
The ASD relay supplies battery voltage (12+ volts) to the fuel injectors and ignition coil(s). With certain emissions packages it also supplies 12-volts to
the oxygen sensor heating elements.
The ground circuit for the coil within the ASD relay is controlled by the Powertrain Control Module (PCM). The PCM operates the ASD relay by
switching its ground circuit on and off.
The ASD relay will be shut-down, meaning the 12-volt power supply to the ASD relay will be de-activated by the PCM if:
-
the ignition key is left in the ON position. This is if the engine has not been running for approximately 1.8 seconds.
-
there is a crankshaft position sensor signal to the PCM that is lower than pre-determined values.
