RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
Compressor Clutch Relay: Description and Operation
The A/C clutch relay (1) is a International Standards Organization (ISO) micro-relay. Relays conforming to the ISO specifications have common
physical dimensions, current capacities, terminal functions and patterns (2). The ISO micro-relay terminal functions are the same as a conventional ISO
relay. However, the ISO micro-relay terminal pattern (or footprint) is different, the current capacity is lower, and the physical dimensions are smaller
than those of the conventional ISO relay
The A/C clutch relay is located in the integrated power module (IPM) in the engine compartment.
The ISO-standard A/C clutch micro-relay is an electromechanical switch that uses a low current input from the powertrain control module (PCM) or
engine control module (ECM) (depending on engine application), to control the high current output to the A/C clutch field coil. The movable, common
feed relay contact is held against the fixed, normally closed relay contact by spring pressure. When the electromagnetic relay coil is energized, it draws
the movable common feed relay contact away from the fixed, normally closed relay contact and, holds it against the fixed, normally open relay contact.
This action allows high current to flow to the A/C clutch field coil.
When the relay coil is de-energized, spring pressure returns the movable relay contact back against the fixed, normally closed contact point. The resistor
or diode is connected in parallel with the relay coil, and helps to dissipate voltage spikes and electromagnetic interference that can be generated as the
electromagnetic field of the relay coil collapses.
The A/C clutch relay terminals are connected to the vehicle electrical system through a receptacle in the integrated power module (IPM). The inputs and
outputs of the A/C clutch relay include:
-
The common feed terminal (30) receives a battery current input from a fuse in the IPM through a fused B(+) circuit at all times.
-
The coil ground terminal (86) receives a ground input from the PCM/ECM through the A/C clutch relay control circuit only when the PCM/ECM
electronically pulls the circuit to ground.
-
The coil battery terminal (85) receives a battery current input from PTC 1 in the IPM through a fused ignition switch output (run) circuit only
when the ignition switch is in the On position.
-
The normally open terminal (87) provides a battery current output to the A/C clutch coil through the A/C clutch relay output circuit only when the
A/C clutch relay coil is energized.
-
The normally closed terminal (87A) is not connected to any circuit in this application, but provides a battery current output only when the A/C
clutch relay coil is de-energized.
The A/C clutch relay cannot be repaired and, if faulty or damaged, it must be replaced. Refer to the appropriate wiring information for diagnosis and
testing of the ISO-standard micro-relay and for complete HVAC wiring diagrams.
