RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
Power Seat Switch: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the seat cushion side shield from the seat.
3. Pull the switch bezel or side shield unit (1) out from the seat far enough to access the switch wire harness connector. Gently pry the locking tabs of
the switch away from the wire harness connector and carefully unplug the connector from the power seat switch module (2).
4. Remove the screws (3) that secure the power seat switch (2) to the side shield unit (1).
INSTALLATION
1. Position the power seat switch (2) on the seat cushion side shield (1) and install the screws (3).
2. Connect the electrical connector.
3. Install the seat cushion side shield on the seat.
4. Connect the battery negative cable.