RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
Camshaft Position Sensor: Service and Repair
REMOVAL
The Camshaft Position Sensor (CMP) (2) on the 5.7L V-8 engine is located on right side of timing chain cover below generator (1).
1. Disconnect electrical connector (3) at CMP sensor.
2. Remove sensor mounting bolt (3).
3. Carefully twist sensor from cylinder head.
4. Check condition of sensor O-ring.
INSTALLATION
The Camshaft Position Sensor (CMP) on the 5.7L V-8 engine is bolted to the right/front side of the timing chain cover or.
1. Clean out machined hole in cylinder head.
2. Apply a small amount of engine oil to sensor O-ring.
3. Install sensor into cylinder head with a slight rocking action. Do not twist sensor into position as damage to O-ring may result.