RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
Battery Tray: Service and Repair
Battery Holddown
REMOVAL
CAUTION: Never operate a vehicle without a battery hold down device properly installed. Damage to the vehicle, components and battery could result.
1. Verify that the ignition switch and all accessories are OFF.
2. Disconnect and isolate the battery negative cable.
3. Remove the bolt (6) from the battery hold down bracket (5) and remove the bracket from the vehicle.
INSTALLATION
1. Clean and inspect the battery hold down bracket (5) and bolt (6).
2. Position the battery hold down bracket in the battery tray.
CAUTION: Be certain that the hold down bracket is properly positioned in the battery tray before tightening the hold down bolt or damage to the
battery and tray may result.
3. Install and tighten the battery hold down retaining bolt.
