RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
Power Steering Fluid Reservoir: Service and Repair
RESERVOIR
REMOVAL
1. Drain and siphon the power steering fluid from the reservoir.
2. Remove the serpentine belt.
3. Remove the power steering pump.
4. Remove the reservoir mounting bolts.
5. Remove the reservoir.
6. Remove the rear bracket to the pump mounting bolts.
INSTALLATION
1. Install the reservoir bracket to the pump housing. Do not reuse the o-rings (install new o-rings). Tighten bolts to 7 Nm (62 inch lbs.).
NOTE: Ensure the reservoir is fully seated onto the pump.
2. Install the reservoir to the bracket/pump body.
3. Install the reservoir mounting bolts. Tighten bolts to 13 Nm (120 inch lbs.).
4. Install the power steering pump.
5. Install the serpentine drive belt.
6. Fill the power steering pump.
