RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
4. Disconnect the pressure hose (2) at the gear (4).
5. Remove the pressure hose from the vehicle.
INSTALLATION
NOTE: Be sure to align the pressure hose so it does not contact the fan shroud or the frame rail.
1. Install the pressure hose to the vehicle.
2. Reconnect the pressure hose (2) at the gear (4). Tighten the hose to 32 Nm (23 ft. lbs.).
3. Reconnect the pressure hose at the pump. Tighten the hose to 36 Nm (27 ft. lbs.).
4. Remove the support and lower the vehicle.
5. Refill the power steering system.
Return Hose - Reservoir to Cooler
RETURN HOSE - RESERVOIR TO COOLER
REMOVAL
1. Drain and siphon the power steering system.
2. Disconnect the return hose at the reservoir.
3. Raise and support the vehicle.
4. Remove the return hose from the routing clamp at the fan shroud.
5. Disconnect the return hose at the cooler.
6. Remove the hose from the vehicle.
INSTALLATION
1. Install the return hose to the vehicle.
2. Reconnect the return hose at the cooler.
3. Reattach the hose to the routing clip at the fan shroud.
4. Remove the support and lower the vehicle.
5. Reconnect the return hose at the reservoir.
6. Refill the power steering system.