RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
NOTE: The bearing rotating torque should be constant during a complete revolution of the pinion. If the rotating torque varies, this indicates a
binding condition.
NOTE: The seal replacement is unacceptable if the final pinion nut torque is less than 285 Nm (210 ft. lbs.).
11. Install propeller shaft with the installation reference marks aligned.
12. Tighten the companion flange bolts to 108 Nm (80 ft. lbs.).
13. Install brake rotors.
14. Check the differential lubricant level.
Rear Axle - 10 1/2AA
SEAL-PINION
REMOVAL
1. Remove axle shafts.
2. Mark propeller shaft and pinion flange for installation reference and remove shaft.
3. Rotate pinion gear three or four times.
4. Measure and record the amount of torque necessary to rotate the pinion gear (1) with an inch pound torque wrench (2).
5. Hold pinion flange (1) with Flange Wrench 8979 (2) and remove pinion flange nut and washer.
