RAM 1500 Truck 4WD V8-5.7L VIN D (2005)
3. Remove the front propeller shaft seal boot (1).
4. Remove the front output shaft seal slinger (1) by bending (2) the slinger ears away from the transfer case.
5. Using a suitable pry tool (2), remove the slinger (1) from the output shaft using care not to damage the shaft.
6. Using a screw and a slide hammer, remove the front output shaft seal.
INSTALLATION
1. Install the new front output shaft seal with Installer MB991168A.
2. Install the front output shaft seal slinger with Installer 8840. Install the slinger onto the shaft until the tool contacts the rear of the output shaft.
3. Install a new seal boot clamp onto the seal boot.
4. Install the seal boot and clamp onto the slinger hub and tighten the clamp with Crimp Tool C-4975-A.
5. Install front propeller shaft.
