RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Cruise Control Servo: Service and Repair
REMOVAL
Fig. 6 Speed Control Servo Location
The speed control servo assembly is attached to the bottom of the battery tray.
1. Disconnect negative battery cable at battery.
2. To gain access to servo, remove plastic wheelhouse splash shield over left-front wheel.
3. Disconnect vacuum line at servo.
4. Disconnect electrical connector at servo.
5. Remove 3 servo mounting screws. Depending on engine application, different sets of mounting lugs are used to support servo to battery tray.
While removing, note proper lugs.
6. Disconnect servo cable at throttle body Refer to Servo Cable Removal/Installation.
Servo Cable Clip Remove/Install - Typical