RAM 1500 4WD V8-59L VIN Z (2002) Cruise Control Servo Cable
Cruise Control Servo Cable: Service and Repair
REMOVAL
1. Disconnect negative battery cable at battery.
2. Remove air intake tube at top of throttle body.
Cable Connection at Throttle Body
3. Using finger pressure only remove speed control cable connector at bellcrank by pushing connector rearward off the bellcrank pin. DO NOT try to
pull connector off perpendicular to the bellcrank pin. Connector will be broken.
4. Squeeze 2 tabs on sides of speed control cable at throttle body mounting bracket (locking plate) and push out of bracket.
5. Remove servo cable from servo. Refer to Speed Control Servo Removal/Installation in this group.
INSTALLATION
1. Install end of cable to speed control servo. Refer to Speed Control Servo Removal/Installation.
2. Install cable into throttle body mounting bracket. Cable snaps into bracket.
3. Install speed control cable connector at throttle body bellcrank pin. Connector snaps onto pin.
4. Install air intake tube to top of throttle body
5. Connect negative battery cable to battery
6. Before starting engine, operate accelerator pedal to check for any binding.