RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
-
Jumper harness connectors are C400 series numbers.
-
Grounds and ground connectors are identified with a "G" and follow the same series numbering as the in-line connectors.
-
Splices are identified with an "S" and follow the same series numbering as the in-line connectors.
-
Component connectors are identified by the component name instead of a number. Multiple connectors on a component use a C1, C2, etc.
identifier.
Electrostatic Discharge (ESD) Sensitive Devices
Electrostatic Discharge Symbol
All ESD sensitive components are solid state and a symbol is used to indicate this. When handling any component with this symbol comply with the
following procedures to reduce the possibility of electrostatic charge build up on the body and inadvertent discharge into the component. If it is not
known whether the part is ESD sensitive, assume that it is.
1. Always touch a known good ground before handling the part. This should be repeated while handling the part and more frequently after sliding
across a seat, sitting down from a standing position, or walking a distance.
2. Avoid touching electrical terminals of the part, unless instructed to do so by a written procedure.
3. When using a voltmeter, be sure to connect the ground lead first.
4. Do not remove the part from its protective packing until it is time to install the part.
5. Before removing the part from its package, ground the package to a known good ground on the vehicle.
Notes, Cautions and Warnings
Additional important information is presented in three ways: Notes, Cautions, and Warnings.
NOTES are used to help describe how switches or components operate to complete a particular circuit. They are also used to indicate different
conditions that may appear on the vehicle. For example, an up-to and after condition.
CAUTIONS are used to indicate information that could prevent making an error that may damage the vehicle.
WARNINGS provide information to prevent personal injury and vehicle damage. Below is a list of general warnings that should be followed any time a
vehicle is being serviced.
WARNING:
-
ALWAYS WEAR SAFETY GLASSES FOR EYE PROTECTION.
-
USE SAFETY STANDS ANYTIME A PROCEDURE REQUIRES BEING UNDER A VEHICLE.
-
BE SURE THAT THE IGNITION SWITCH ALWAYS IS IN THE OFF POSITION, UNLESS THE PROCEDURE REQUIRES IT TO
BE ON.
-
SET THE PARKING BRAKE WHEN WORKING ON ANY VEHICLE. AN AUTOMATIC TRANSMISSION SHOULD BE IN PARK.
A MANUAL TRANSMISSION SHOULD BE IN NEUTRAL.
-
OPERATE THE ENGINE ONLY IN A WELL-VENTILATED AREA.
-
KEEP AWAY FROM MOVING PARTS WHEN THE ENGINE IS RUNNING, ESPECIALLY THE FAN AND BELTS.
-
TO PREVENT SERIOUS BURNS, AVOID CONTACT WITH HOT PARTS SUCH AS THE RADIATOR, EXHAUST MANIFOLD(S),
TAIL PIPE, CATALYTIC CONVERTER, AND MUFFLER.
-
DO NOT ALLOW FLAME OR SPARKS NEAR THE BATTERY. GASES ARE ALWAYS PRESENT IN AND AROUND THE
BATTERY.
