RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
Power Interrupt Connector/Switch: Service and Repair
IOD FUSE
REMOVAL
The Ignition-Off Draw (IOD) fuse is disconnected from Integrated Power Module fuse cavity # 51 when the vehicle is shipped from the assembly
plant. Dealer personnel must reconnect the IOD fuse when the vehicle is being prepared for delivery in order to restore full electrical system operation.
1. Turn the ignition switch to the OFF position.
2. Remove the Integrated Power Module cover.
3. Grasp the outer tabs of the IOD fuse holder unit in fuse cavity # 51 between the thumb and forefinger and pull the unit firmly upward.
4. Install the Integrated Power Module cover.
INSTALLATION
1. Turn the ignition switch to the OFF position.
2. Remove the Integrated Power Module cover.
3. To install the IOD fuse, use a thumb to press the IOD fuse holder unit in fuse cavity # 51 firmly into the Integrated Power Module.
4. Install the Integrated Power Module cover.
