RAM 1500 Truck 4WD V8-5.9L VIN Z LDC (1999)
Console: Service and Repair
Overhead Console Replacement
Overhead Console Latch Tabs
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Open the garage door opener storage bin door and locate the two overhead console latch tabs near the front of the bin.
3. While pulling gently downward on the front of the overhead console, push the latch tabs forward until each latch is disengaged from its receptacle
in the inner roof panel.
4. Slide the overhead console rearward far enough to disengage the two mounting hooks on the rear of the housing from the mounting holes in the
inner roof panel.
5. Lower the overhead console from the headliner far enough to access the wire harness connector.
6. Disconnect the roof wire harness connector from the overhead console wire harness connector.
7. Remove the overhead console from the vehicle.
INSTALLATION
1. Position the overhead console near the mounting location on the headliner in the vehicle.
2. Reconnect the roof wire harness connector to the overhead console wire harness connector.
3. Engage the two mounting hooks on the rear of the overhead console housing in the mounting holes in the inner roof panel.
4. Slide the overhead console forward far enough to align the two latches on the front of the housing with their receptacles in the inner roof panel.
5. Push upward firmly and evenly on the front of the overhead console until each of the two latches is fully engaged in its receptacle in the inner roof
panel.
6. Close the garage door opener storage bin door.
7. Reconnect the battery negative cable.