RAM 1500 Truck 4WD V8-59L VIN Z LDC (1999) - Recall for PCM Reprogramming
(or previously installed authorized software update label) matches the part number displayed on the MDS. Press the "OK" button, then
continue with Section C.
6.
Select the NEW SOFTWARE PART NUMBER with the light pen and click UPDATE CONTROLLER SOFTWARE.
7.
The MDS2 and DRB III will prompt for any operator action needed during the remainder of the reprogramming process.
NOTE:
Due to the PCM flash procedure, diagnostic trouble codes (DTC's) may be set in other modules (ETAX, BCM, MIC, SKIM, ABS)
within the vehicle (if so equipped). Some DTC's may cause the Malfunction Indicator Light (MIL) to illuminate. All of the DTC's relate
to a loss of communications with the module that is being flashed. Check all modules, record the trouble codes. and erase the trouble
codes prior to returning the vehicle to the customer. Erase any trouble codes in the PCM only after all other modules have had their
trouble codes erased.
B.
Install Authorized Software Update Label:
Type or print (with a ballpoint pen) the part number, dealer code and date on the Authorized Software Update Label (Figure 1) and attach it to the
PCM. Cover the label with the clear plastic portion of the label.
C.
Install the Authorized Modifications Label:
Type or print (with a ballpoint pen) the recall number, dealer code and date on the Authorized Modifications Label (Figure 2). Then attach the
label near the VECI label.
D.
Complete Proof of Correction Form for California Residents:
This recall is subject to the State of California Registration Renewal/Emissions Recall Enforcement Program. Complete a Vehicle Emission Recall
Proof of Correction Form (Form No. 81-016-1053) and supply it to vehicle owners residing in the state of California for proof that this recall has
been performed when they renew the vehicle registration.
