RAM 1500 Truck 4WD V8-5.9L VIN Z LDC (1999)
Shifter A/T: Service and Repair
REMOVAL
Gear Shift Lever
1. Support the steering column assembly as shown by using a suitable size socket.
2. Disconnect over drive switch wiring.
3. Using a drift of the appropriate size drive the pin out of the steering column and gear shift lever. Remove the gear shift lever from the steering
column assembly.
INSTALLATION
1. Support the steering column using a suitable size socket.
2. Install the gear shift lever into the steering column assembly. Align the pin holes in the gear shift lever and the steering column assembly.
3. Carefully Install the pin into the steering column assembly and through the shift lever. If the pin binds check the alignment on the holes. Be sure
pin is fully installed into the steering column assembly.
4. Connect over drive switch wiring.