RAM 1500 Van V6-239 3.9L Magnum (1995)
2. Install the trim panel attaching screws in the body interior panels. Tighten the screws with 2 Nm (17 in. lbs.) torque. Avoid over-tightening the
screws.
3. Position the sunvisors and retaining clips on the windshield header with the screw holes aligned.
4. Install the attaching screws in the windshield header. Tighten the screws with 2 Nm (17 in. lbs.) torque. Avoid over-tightening the screws.
SIDE CARGO DOOR HEADER AND PILLAR TRIM PANELS REMOVAL
Side Cargo Door Header & Pillar Trim Panels
1. If applicable, remove the front door header trim panel end screw from the door header.
B-Pillar Grab Handle
2. Remove grab handle screws and grab handle from B-pillar.
3. Remove the trim panel screws from the upper body interior side panels.
4. Remove the push-in fasteners from the lower body interior side panel (use special tool C-4829).
5. Remove the trim panels from the body interior panels.
INSTALLATION
1. Position the trim panels at the body interior side panels.
2. Install the trim panel screws and push-in fasteners in the body interior side panels. Tighten the screws to 2 Nm (17 in. lbs.) torque.
3. Install grab handle and grab handle screws on B-pillar. Tighten the screws to 2 Nm (17 in. lbs.) torque.
SIDE UPPER TRIM PANELS AND REAR CARGO DOOR HEADER TRIM PANEL REMOVAL
When removing a body interior trim panel that is overlapped by an adjacent trim panel, remove the nearest attaching screw in the adjacent trim
panel to avoid possible damage to both panels.
1. For convenience, remove the rear passenger seats. If necessary refer to the removal procedures.
