RAM 1500 Van V6-239 3.9L Magnum (1995)
6. Using a press to compress thrust plate, install retaining plate with the center opening of ring with bolt hole nearest the access hole.
7. Using a suitable socket and press, install driveshaft seal into housing until it bottoms.
8. Install bearing onto driveshaft, then slide assembly into housing while rotating driveshaft so shaft serrations engage with rotor.
9. Insert retaining ring ensuring large tab of ring is properly located. Refer to.
10. Install flow control spring, control valve, O-ring seal and O-ring.
11. Install reservoir or return tube, then clips if equipped.
CB Series
DISASSEMBLE
