RAM 1500 Van V6-239 3.9L Magnum (1995)
8. Holding ball retaining tool against end of wormshaft, thread rack piston onto worm by rotating stub shaft counterclockwise.
9. Remove ball retaining tool when rack piston is completely threaded on wormshaft.
10. Coat new sector shaft O-ring with grease to hold it in place, then position O-ring in side cover.
11. Move rack piston until teeth are centered in sector shaft opening.
12. Install sector shaft and side cover so sector shaft center tooth is centered with tooth gap at center of rack piston.
13. Install side cover bolts, lock washers and rack piston plug.
14. Install new housing end cover O-ring, end cover and retaining ring.
15. Adjust wormshaft thrust bearing preload and overcenter preload.
