RAM 1500 Van V6-3.9L VIN X (1997)
Cruise Control Vacuum Reservoir: Service and Repair
REMOVAL
1. Disconnect negative battery cable.
Fender Extension Remove/Install - Typical - Left Side Shown
2. Remove 3 screws holding right fender extension. Pull extension towards outboard side of vehicle to unfasten hook-and-loop fastener patch.
Vacuum Reservoir Remove/Install
3. Remove screw holding top of reservoir bracket.
4. Pull vacuum reservoir up to remove lower bracket from locating hole.
5. Disconnect all hoses from reservoir.
6. Remove reservoir by rotating it out at top of opening.
7. Reverse removal procedures to install. Tighten bracket screw to 4.0 Nm (35 in lb).
