RAM 1500 Van V6-3.9L VIN X (1997)
b. Install support bracket (generator mounting bracket-to-intake manifold). Tighten bolts to 54 Nm (40 ft. lbs.) torque.
CAUTION: When installing the-serpentine accessory drive belt, the belt must be routed correctly. If not, the engine may overheat due to the
water pump rotating in the wrong direction. Refer to illustration for correct engine belt routing. The correct belt with the correct length must be
used.
c. Position the drive belt over all pulleys except the idler pulley (located between the generator and A/C compressor).
