dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

ABOUT US
Automatic Shut Down (ASD) Relay <--> [Main Relay (Computer/Fuel System)] > < Initial Inspection and Diagnostic Overview

RAM 1500 Van V6-3.9L VIN X (1997)

Page 1
background image

Powertrain Control Module: Service and Repair

Fig 1  Powertrain Control Module

REMOVAL

1. Disconnect the negative battery cable at battery.
2. Carefully unplug the three 32-way connectors from JTEC.
3. Remove three Jeep/Truck Engine Controller (JTEC) mounting bolts and remove JTEC from vehicle.

INSTALLATION

1. Install JTEC and mounting bolts to vehicle.
2. Tighten bolts to 4 N.m (35 in. lbs.).
3. Check pin connectors in the JTEC and the three 32-way connectors for corrosion or damage. Repair as necessary
4. Install three 32-way connectors.
5. Install battery cable.

Automatic Shut Down (ASD) Relay <--> [Main Relay (Computer/Fuel System)] > < Initial Inspection and Diagnostic Overview