RAM 1500 Van V8-5.2L CNG VIN T (1999)
9.
Inspect the rear latch torsional spring to ensure that it is properly positioned. If the rear latch torsional spring is NOT positioned as shown in
Figure 7, perform the Repair Procedure. If the spring is properly positioned and the latch rod clips were attached (Step 5), this bulletin will not
correct a door that will not close/latch complaint. Further diagnosis is required.
PARTS REQUIRED:
REPAIR PROCEDURE:
THIS REPAIR IS COMPATIBLE WITH IDAIMLERCHRYSLER'S MOBILE SERVICE PROGRAM AND DOES NOT REQUIRE HOISTS OR
OTHER FULL SERVICE FACILITY SPECIAL EQUIPMENT.
1.
Remove the rear latch assembly (if not already performed). Refer to the 2000 Ram Van/Wagon Service Manual (Publication No.81-370-0007),
page 23-42 "Sliding Cargo Door Rear latch Removal."
2.
Remove the sliding door inside handle attaching screw (Figure 2) (if not already performed).
3.
Remove the inside sliding door handle and spacers (if not already performed).
4.
Remove the lock knob from the knob latch rod (if not already performed).
5.
Remove the latch cover screws from the door panel (if not already performed).
6.
Remove the cover from the door panel (if not already performed).
7.
Remove the front latch-to-rear latch control rods from the front latch assembly.
8.
Remove the latch rods from the inner door panel.
9.
Using a grinder, grind down the rear latch reinforcement trim edge so that the reinforcement is flush with the inner door panel rear latch opening.
10.
To prevent corrosion, apply a brushable primer to the exposed bare metal.
11.
Connect the latch rods p/n 55076381AB and p/n 55346503AB to the front latch.
12.
Position the rear latch p/n 55347099AC near the rear latch opening.
13.
Attach the latch rods to the rear latch.
14.
Install the latch screws in the door inner panel. Tighten the screws to 11 N.m (95 in. lbs).
