RAM 1500 Van V8-5.2L CNG VIN T (1999)
Glove Box Remove/Install
3. Remove the three screws that secure the glove box hinge to the instrument panel lower glove box opening reinforcement.
4. Remove the glove box from the instrument panel.
INSTALLATION
1. Position the glove box hinge to the instrument panel lower glove box opening reinforcement.
2. Install and tighten the three screws that secure the glove box hinge to the instrument panel lower glove box opening reinforcement. Tighten the
screws to 3.4 Nm (30 in. lbs.).
3. Roll up the glove box into the instrument panel. Refer to Glove Box - Roll Down in the Replacement for the procedures.
4. Reconnect the battery negative cable.
Glove Box Component Replacement
The glove box bin and inner door unit and the glove box handle and latch unit are available for service. The glove box outer door and the glove box
hinge are serviced only in the complete glove box assembly.
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.
REMOVAL
Handle and Latch
1. Disconnect and isolate the battery negative cable.
2. Roll down the glove box from the instrument panel. Refer to Glove Box - Roll Down in the Replacement for the procedures.
Glove Box Latch And Handle Remove/Install
3. Remove the four screws that secure the handle and latch unit to the glove box inner door.
4. Remove the handle and latch unit from the glove box inner door.
Inner Door and Bin
