RAM 1500 Van V8-5.2L CNG VIN T (1999)
mounting screws to 4.5 Nm (40 in. lbs.).
4. Position and route the vacuum harness over the distribution duct.
5. Install the one screw that secures the vacuum harness retaining strap near the left end of the distribution duct. Tighten the mounting screw to 2.2
Nm (20 in. lbs.).
6. Plug in the two vacuum harness connections to each of the two vacuum actuators on the upper half of the distribution duct.
7. Reinstall the blend-air door motor to the distribution duct. See Blend-Air Door Motor Removal and Installation.
See: Air Door/Air Door Actuator / Motor/Service and Repair/Blend Door Actuator Replacement
8. Reinstall the instrument panel to the vehicle. Refer to Instrument Panel Assembly Removal and Installation.
See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel Assembly Replacement
9. Connect the battery negative cable.
