RAM 1500 Van V8-5.2L CNG VIN T (1999)
CAUTION: Whenever fuel pump module is serviced, module gasket must be replaced.
1. Thoroughly clean locknut threads and mating fuel tank threads. Use a soap/water solution. Do not use carburetor cleaner to clean threads.
2. Using new gasket, position fuel pump module into opening in fuel tank, Be sure rubber gasket remains in place.
3. Apply a small amount of clean engine oil to locknut threads.
4. Position locknut over top of fuel pump module. Tighten finger tight.
Top View of Fuel Pump Module
5. Rotate module assembly until index arrow on pump module is aligned between index marks on fuel tank. This step must be followed to prevent
float/float rod from contacting sides of fuel tank.
6. Install Special Tool 6856 to locknut.
7. Tighten locknut to 54 Nm (40 ft. lbs.) torque. While tightening locknut, be sure module has not rotated.
